Estimodeling: A How-To Guide to Getting Started [Previously Recorded]
It’s all about early data. By leveraging your Tekla software with Qnect’s connection modeling capabilities, you will estimate faster, with more accuracy and get insight into optimization opportunities. Typical results include reduced costs, reduced work hours and increased profits.
View this recorded Webinar to see how the Qnect and Trimble combination can be used to build a connected, optimized model resulting in more accurate and profitable bids. In addition, see how to transfer data to your cost analysis software such as FabSuite, FabTrol or STRUMIS.
In this 30 minute Webinar, you will learn how-to:
> Build a stick model appropriate for estimating
> Connect the model while optimizing to reduce costs
> Transfer the data to your MIS tools to increase profits
There is also a short Q&A session at the end based on questions asked by the audience.
“Bolt optimization is always helpful and will become a new standard in estimating and designing.” - Erleen Hatfield