WEBINAR ENDED
Edit
About This Webinar
Too many times, injection molders just guess what size temperature-control unit (TCU) is needed for their process or just use the same old one they have always used. All TCUs are not created equal! A general-purpose TCU might work, but are you getting the best performance from the TCU and mold? Can you improve part quality and improve cycle time? In this webinar, Wittmann Battenfeld will show you what to consider when applying a TCU to a process and how proper sizing can benefit your bottom dollar.

Presented by:

Wittmann Battenfeld logo
Agenda
  • Heating
  • Cooling
  • Pump selection
  • Direct or indirect cooling?
Presenter
1620997769-de7e7274440f792e
Wes Moffitt
Regional Sales Manager - Auxiliaries
Wes started in plastic injection molding as a sales rep in 1997 after his time in the U.S. Coast Guard. He joined Wittmann in early 2004 as inside sales for the water group. Wes then advanced to the water products product manager in the fall of 2004, along with product management for dryers in 2005. In 2014, he switched roles and became the East Coast regional sales manager for all auxiliary products. Since 2017, due to market strength and sales volume, he concentrates solely on regional sales in the Southeast.