The objective of this training workshop is to review the modular process engineering requirements and methods. We will review the process engineering differences between traditional stick-built designs vs. modular designs and what process engineering considerations are required for modular designs. This training workshop is intended to be interactive.
Participants of this workshop should leave with an understanding of the following:
What collaboration methods are required for process engineering?
How the process design is developed for modular designs?
What are the modular process design differences compared to traditional stick-built designs?
What are the process engineering requirements for modular designs?
• Process engineering collaboration requirements
• Differences compared to traditional stick-built designs
• Modular process requirements including
o Process design development during the FEED (FEL3) phase
o Loss prevention requirements
o Equipment selection
o Module boundaries
o Spill containment philosophy
o Underground drain piping
Note: We will need a minimum number of registrants to proceed with this course. If we do not achieve the minimum number of registrants we may need to reschedule or cancel the course.